Description

FAAC E145S Control Panel – 230V

Control Panel for the Control of One or Two 230V Motors.

These Control Panels are a simple swap out replacement for your existing E145 Control Panel, so if you have a faulty panel you can just purchase a new one and swap it straight out.

Nothing complicated about it at all, just disconnect the connection blocks from the control panel, unscrew and remove the old panel and replace with the new, then connect the connection blocks.

A new panel may be needed due to water ingress or insect invasion which has caused a short which will burn out your old panel.

All of your motor settings are within the old control panel so the new panel will need to be re-commissioned.

E145S Control Panel:

This control board has been designed to control both swing-leaf and sliding-leaf gates for vehicle and pedestrian access control.

• The E145 comes with safezone technology – obstacle detection and reversal on contact. (when the optional encoder is used).

• Greentech are solutions which save up to 90% of power compared to traditional systems ( thanks to the innovative power supply switching systems.

• The board is able to automatically adapt to different input voltages (from 90V~ to 260V~), maintaining a constant output voltage to accessories.

• Added connectivity – the new boards support BUS 2EASY and can be programmed from PC/MAC

• Backward compatible – can be fitted to exisiting installations

• Can automatically find the deceleration and stop points during setup when using the safecoder with physical stops.

• In event of power failure the optional absolute encoder keeps the leaf position memorised

• It has embedded radio decoding in order to support only orginal FAAC transmitters (upto 1600 radio codes can be stored). It also has a 5 pin connector for plugging existing radio controls.

• Built in timer (programmed via a PC).

• Traditional and Bus photocell inputs.

• Event log (via PC).

2 programming levels are available from the board (BASIC and ADVANCED), using buttons and LCD display, 3rd level from PC. This board also allows you the option to program using PC or MAC, connected via USB. With the Easyboard programming software you can choose whether to follow the wizard guided installation or customise your system in all its parts. The board is prepared ready for future communication modules

• E145S Technical Spec:

  • 230V Supply
  • 230V Motor Outputs
  • Power Absorbed – 4W Stand-by, 2W Sleep,
  • 800W Max Load
  • Protection Fuses – F1=F10AH250V
  • Terminal Board Inputs
    • Bus 2 Easy Inputs
    • Mains Power Supply From 90 to 260V
    • Inputs from IN1 to IN5
    • Limit Switch
  • Terminal Board Outputs
    • Motors
    • Flashing Light
    • Power Supply To Accessories
    • Electric Lock (Lock1 and Lock2)
    • Out1 and Out2 (programmable)
  • Work Time  – Self learned through setup (max 4 min and 10 sec)
  • Pause Time – Programmable (0 to 9 min and 50 sec)
  • Connector Inputs – Decoder/minidec/RP, X-com, XF433/868 Module, USB-A, USB-B

Technical Data Downloads:

• Manual

What You Get:

• Control Panel with housing
• Instructions

Panel Specs:

• See individual panels above

Other Information:

• These panels can be used with other motors of the same voltage and similar spec.